CV joints done! |
Post Reply |
Author | |
silverbullet
Yardie Ingenieur Joined: 10 Jun 09 Status: Offline Points: 743 |
Post Options
Thanks(0)
Posted: 19 May 10 at 10:12 |
Well the nearside, anyway. What a pig of a job. Exhaust completely in the way...and that's on it's last legs. CV's are Audi 100/A6 up to about '95, 108mm.
It's still got a slight vibration over 60, so must be the n/s front wheel bearing (did the o/s) Must do tomorrow evening, the kit's no good on the shelf
Same as later german vans with sliding calipers, FAG kit 713 6114 10 Edited by silverbullet - 19 May 10 at 10:14 |
|
Have I missed anything?
|
|
silverbullet
Yardie Ingenieur Joined: 10 Jun 09 Status: Offline Points: 743 |
Post Options
Thanks(0)
|
Hmmm. Did the nsf wheel bearing too. Better, but there's still a cyclic shudder that passes through the bus about every 6 seconds at 60 mph. Worse on smoother roads or that crappy concrete bit of the M25 south of Chertsey. Wonder if it's got a bit of wheel flutter from a tired rear damper?
Hope it's not a rear wheel bearing...
|
|
Have I missed anything?
|
|
Post Reply | |
Tweet |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |