The Brick-yard Homepage Brickwerks
Forum Home Forum Home > LT, Crafter & Sprinter Section > LT2 and sprinter forum
  New Posts New Posts RSS Feed - Lt35 2.8
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Lt35 2.8

 Post Reply Post Reply
Author
Message
John1303 View Drop Down
Newbie
Newbie
Avatar

Joined: 22 Jun 16
Location: Ipswich
Status: Offline
Points: 2
Post Options Post Options   Thanks (0) Thanks(0)   Quote John1303 Quote  Post ReplyReply Direct Link To This Post Topic: Lt35 2.8
    Posted: 22 Jun 16 at 22:22
Can anyone tell me where the crank sensor is located on my lt 35 2.8 AUH engine ?
Back to Top
tellytubby View Drop Down
Groupie
Groupie


Joined: 29 Mar 16
Location: Glasgow
Status: Offline
Points: 154
Post Options Post Options   Thanks (0) Thanks(0)   Quote tellytubby Quote  Post ReplyReply Direct Link To This Post Posted: 24 Jun 16 at 00:05
Not my engine but this might help from the manual






sensor is at location 1 rear of the engine.


Also


Checking components and functions

Checking the Engine Speed Sender

The engine speed sender is the speed and reference mark sender. The engine stops in the case of a failure.

Special tools, workshop equipment, test and measuring equipment and accessories required

? Testing box V.A.G 1598/30
? Hand-held multimeter V.A.G 1526 or Multimeter V.A.G 1715
? Measuring aids set V.A.G 1594
? Current flow diagram
 
 
 
Testing Procedure

? Switch the ignition off.
? Separate the connector for the engine speed sender.
=>Overview of installation locations, page 23-5.
? ? Measure the resistance between contacts 2+3 of the connector.
    Setpoint value: approx. 1 k?
If the setpoint value is not reached:
 
 
 
? Replace the engine speedsensor (G28).
=> Repair Group 13; Dismantling and assembling engine

If the setpoint value is reached:

? ? Connect the testing box V.A.G 1598/30 to the control unit wiring loom. The engine control unit is not connected in the process.
 
 
 
? ? Check wires between test box and 3-pin connector for breaks using current flow diagram.
    Contact 1+socket 1/04
    Contact 2+socket 3/31
    Contact 3+socket 3/06
    Cable resistance: max. 1.5?
? Check for short-circuits among the cables at the 3-pin connector in accordance with the current flow diagram.
    Setpoint value: 8?
If not fault in the cables is discovered:

? Replace the control unit for diesel direct injection system (J248) => page 23-61. 

Back to Top
 Post Reply Post Reply

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 12.06
Copyright ©2001-2023 Web Wiz Ltd.

The WebThis site